Release Agents

Showing all 3 results

  • Sale!

    Resin Barrier/ Release Tape

    12.3519.85 (ex vat)

    This special high quality tape is designed specifically for use as a barrier or release tape for industrial resins like epoxy. It is smooth, very strong, non-stretch and totally non-stick for epoxy resin making it incredibly useful for a wide range of epoxy resin applications.

  • Sale!

    PVA Liquid Release Agent

    14.5378.64 (ex vat)

    PVA (polyvinyl alcohol) is a water-based liquid plastic that can be applied to waxed moulds to prevent moulded parts from sticking. PVA is not always required. Often laminators rely solely on mould release wax to create a surface contaminant on the mould that allows parts to be removed. However, on complicated moulds and on new moulds, when the risk of a part sticking in a mould is greatest, PVA can be applied over a waxed mould. For General Health Information see section on hazards.

  • Sale!

    Meguiar’s Wax Release Agent – Mirror Glaze No.8 Paste

    23.50 19.75 (ex vat)

    Description: High quality maximum mold release paste wax Objective: To create a barrier-film that provides multiple releases with ultra high gloss finished parts on new and seasoned molds. Features: – The industries first and most widely used mold release wax – Recognized worldwide as the industry standard for paste mold release waxes – Wax of choice when maximum release power is required – Withstands exothermic temperatures up to 250° F (121º C) Benefits: – Specially formulated to provide the maximum number of releases – Especially useful on tooling, new molds, and production use Tools Needed: Meguiar’s Foam Applicator (W-0004) or 100% cotton terry cloth towel Mold Prep: New mold or plug must be fully cured before using the Meguiar’s Maximum Mold Release Wax (M-08). Safety Tip: Always wear appropriate eye and skin protection. Safety Data: Material Safety Data Sheets are available for all Meguiar’s products and should be consulted prior to use of the product. Professional Tips: For the highest quality parts, precede Meguiar’s Maximum Mold Release Wax (M-08) with Meguiar’s Velocity line of cleaner, compounds, and polishes. DIRECTIONS: Meguiar’s Maximum Mold Release Wax (M-08) should be applied at ambient room temperatures above 50º F (10º C). New and Seasoned Molds: 1. Apply by hand five (5) to eight (8) coats of Meguiar’s Maximum Mold Release Wax (M-08). o Apply a thin coat of wax, wait for approximately 5 to 10 minutes for the wax to haze up. o Wipe off the haze using a 100% cotton terry cloth towel. o Wait for an additional 20 to 30 minutes for the wax to fully cure then apply next coat. 2. Once all five (5) to eight (8) coats have been applied, the mold is ready for production. 3. For the first five (5) pulls add one (1) additional coat between each pull. 4. After the fifth pull, run mold until release becomes slight snug then apply one (1) additional coat of wax.

    Add to basket