250ml

Showing all 6 results

  • Sale!

    Calibrated Containers

    1.684.95 (ex vat)

    Perfect for measuring small amounts of Catalyst (Hardener) into Polyester or Epoxy Resins / Topcoats / Gelcoat.  Self Releasing – Can be re-used.

    • Conforms to ISO 7056 – 1981 (E) and BS 5404 Part 1.
    • Strong & flexible Polypropylene.
    • High translucency
    • Permanent graduations are moulded in for reproducibility.
    • Excellent chemical resistance.
    • Ideal for repair or laminating small areas
  • Catalyst

    1.9749.95 (ex vat)

    All resins, gelcoats and topcoats must have catalyst (hardener) added to start the curing process. The amounts vary between 1% – 4% by weight depending on the required cure time and temperature. Please view our Catalyst mixing chart. Catalyst is a corrosive material and must be handled with special care. Dispensers are strongly recommended for safe and accurate use. See section on hazards. Please Note: In order to comply with ADR Limited Quantity (Carriage of Dangerous Goods by Road) we can only ship in maximum units of 100ml eg: 1kg = 10 x 100ml. For large quantities, please contact us on +353 1 466 3786.

  • Sale!

    Summer Catalyst

    2.2157.44 (ex vat)

    All resins, gelcoats and topcoats must have catalyst (hardener) added to start the curing process. The amounts vary between 1% – 4% by weight depending on the required cure time and temperature. Please view our Catalyst mixing chart. Catalyst is a corrosive material and must be handled with special care. Dispensers are strongly recommended for safe and accurate use. See section on hazards. Please Note: In Order to comply with ADR Limited Quantity (Carriage of Dangerous Goods by Road) we can only ship in maximum units of 100ml eg: 1kg = 10 x 100ml. For large quantities, please contact us on +353 1 466 3786.

  • Sale!

    Winter Catalyst

    2.6568.93 (ex vat)

    Winter Catalyst (HBO-50) has been specifically designed for addition to CrysticCOOL Cure Resin and topcoats to start the curing process. The amounts vary between 1% – 4% by weight depending on the required cure time and temperature. It can also be added to other polyester resins / Gelcoats and Topcoats – but it will be similar to the summer catalyst cure times. Please view our Catalyst mixing chart. Catalyst is a corrosive material and must be handled with special care. Please Note: In order to comply with ADR Limited Quantity (Carriage of Dangerous Goods by Road) we can only ship in maximum units of 100ml eg: 1kg = 10 x 100ml containers. For large quantities, please contact us on +353 1 466 3786.

  • Sale! Plastic Squeeze Bottle

    Plastic Squeeze Bottle with Angled Straw

    2.984.87 (ex vat)

    Plastic Squeeze Bottle with Angled Straw for Dispensing Water

    Plastic wash bottles with Swan neck and a fine control tip. Ideal for washing down. Polypropylene screw closure with its angled stem and draw tube moulded in one piece for leak-proof applications

    Available in three sizes; 250ml, 500ml & 1000ml.

  • Sale!

    Solution MW Wax

    5.9539.80 (ex vat)

    A wax solution is added to the gelcoat mix at the rate of 2% where a completely tack free surface is required. It eliminates the surface tackiness caused by gelcoat when used as a final coating in sheating. Gelcoats applied with wax solution added will always needed to be abraded if further coats are required. (6% Strength) For General Health Information see section on hazards.