Epoxy Filler – SP Microfibers 500gm

19.86 (ex vat)

Related Products


Gurit SP Microfibres are very fine wood-cellulose fibres commonly used to create structural adhesives for bonding both wood and grp.

Because any low viscosity resin system is readily absorbed into a porous surface such as wood, an unfilled adhesive may tend to give a ‘dry joint’. With their absorbent properties, microfibres can retain a significant quantity of adhesive within a joint and limit resin absorption into the surrounding surface, thus ensuring an adequate resin supply for adhesion. Where the strongest bond is required, e.g. timber scarf joints, microfibres should always be used in preference to hollow sphere-types of filler.

For bonding parallel to the grain with lower density, lower strength timbers, such as cedar or obeche, a microballoon mix is often adequate, and is of lower density. Weight – 500gm

Technical Details;

Composition: Milled bleached cellulose wood pulp Appearance: White ‘fluffy’ fibrous consistency Particle Size: 200 – 300 microns Particle Density: Particles absorb resin Bulk Density: 100g/litre approx.

Colloidal Silica + Microfibres + Epoxy = Adhesive Mix

For General Health Information see section on hazards.

Additional information


, ,

Data Sheets

pdficon_largeMicrofibres (TDS)

pdficon_large Microfibres (MSDS)

No FAQ Found

Related Products